I too have those Hornby ruins, I'll add photos in a sec.
BUT I have to say your original posts with the DAS ruins are totally spot on, they are so good I plan to have a go myself and try it as well. Thank you for sharing such a lovely piece of modelling.
6869
6868
5173
Ancient castle walls etc
-
- Posts: 58
- Joined: Mon May 27, 2019 10:48 am
- Contact:
-
- Posts: 58
- Joined: Mon May 27, 2019 10:48 am
- Contact:
-
- Posts: 131
- Joined: Fri Oct 19, 2018 1:48 am
- Location: Melbourne, Australia
- Contact:
-
- Posts: 908
- Joined: Thu Oct 04, 2018 7:42 pm
- Contact:
Re: Ancient castle walls etc
Scribing Depron foam can do it, but you always have that surface to disguise.
I use Foamex, which is a self skinning PVC foam used by signage makers. My son gets me copious amounts from 2 mm to 10 mm thick. It is self supporting and does not warp. It carves and engraves with whatever you like for tools and takes paint beautifully. I have so far used it for brick, block and even shiplap walls and have done experiments on it to make a church, built of stone (dressed), stone (rough) and carrstone and it worked beautifully. It also makes very nice paviours and setts (cobbles). I also used it with 40 grit sandpaper rollered into the surface to represent rough stucco in 1/32nd and 1/43rd scales and that, too, works a treat. Engrave a few jagged cracks and you have a one stop shop for all surfaces.
Beg some samples from your local exhibition and /or signage companies.
I sent some to Iain Robinson when he was at the height of his professional modelmaking career and he replaced all use of Das with Foamex.
Martin
I use Foamex, which is a self skinning PVC foam used by signage makers. My son gets me copious amounts from 2 mm to 10 mm thick. It is self supporting and does not warp. It carves and engraves with whatever you like for tools and takes paint beautifully. I have so far used it for brick, block and even shiplap walls and have done experiments on it to make a church, built of stone (dressed), stone (rough) and carrstone and it worked beautifully. It also makes very nice paviours and setts (cobbles). I also used it with 40 grit sandpaper rollered into the surface to represent rough stucco in 1/32nd and 1/43rd scales and that, too, works a treat. Engrave a few jagged cracks and you have a one stop shop for all surfaces.
Beg some samples from your local exhibition and /or signage companies.
I sent some to Iain Robinson when he was at the height of his professional modelmaking career and he replaced all use of Das with Foamex.
Martin
Who is online
Users browsing this forum: No registered users and 0 guests