LOW GHYLL

[Steve M]

Before lunch I finished the support rings and put one vertical rail in place to hold everything square.

20210114_134702 by Steve Mumford, on Flickr

I’ve now added the remaining rails and the standoffs. It can dry overnight before getting a coat of red primer tomorrow.

20210114_142022 by Steve Mumford, on Flickr

[Brian]

Wow, that's some detailed parts to cut out. What are you using to remove them from the fret?

[Steve M]

Single edge razor blade - not a Stanley blade or scalpel, both are too thick!

[Brian]

Oh, that's something else I'll need to order.
Glue ??? PVA possibly?

[Steve M]

Amazon, about £6 for 100.
I’m using aliphatic resin from Deluxe Materials as it sets a little harder than PVA.

[Brian]

That's great Steve. Thanks for the info..

[Steve M]

A squirt of red primer and a wash of black.

20210115_111358 by Steve Mumford, on Flickr

And finally, all done. The second ladder will probably end up on the engine shed when I next upgrade that.

20210115_115349 by Steve Mumford, on Flickr

[Walkingthedog]

Ladder much better vertical than the original sloped version.

[bulleidboy]

Looks as though its always been there - well done.

[teedoubleudee]

Looks very good.