New Loco not working on programming track

station master
Posts: 49
Joined: Tue Oct 09, 2018 9:07 am
Location: North West
Contact:

Re: New Loco not working on programming track

#31

Post by station master »

Evening gents, thank you for all the suggestions and guidance, I have tried to programme on the main and again on a programming track, still no joy any further suggestions?
User avatar
RAF96
Posts: 525
Joined: Fri Oct 05, 2018 6:33 am
Location: Dereham, Norfolk, UK
Contact:

Re: New Loco not working on programming track

#32

Post by RAF96 »

Try programming in REG mode. It often works with an awkward decoder when Direct mode doesn’t.
User avatar
Brian
Posts: 2188
Joined: Thu Oct 04, 2018 3:49 pm
Location: SE Kent
Contact:

Re: New Loco not working on programming track

#33

Post by Brian »

As I said in an earlier post "Devils own work"!

OK suggestion... So programme on the main as this is where you get full track current ... Ensure the rails are spotlessly clean, even if they look clean give them another clean.
Next, ensure the locos pick up wheels rims are also spotlessly clean too.
Now, just before attempting the programming gently press down on the loco and begin the programming maintaining the downward pressure until prog has finished. (You may need help in doing this as three hands are needed!)

If that doesn't work then its possible the decoder is defective? Contact Hornby Customer Service for help and return.
Image << Click the Icon to go to my website
brian1951
Posts: 1261
Joined: Thu Oct 04, 2018 5:52 pm
Contact:

Re: New Loco not working on programming track

#34

Post by brian1951 »

brian1951 wrote: Sat Jan 16, 2021 4:15 pm Firstly make sure the programming track is spotless, place your finger on top of loco with light pressure on it while using your powercab, failing that you may need to do your adjustments on the main.
If you have tried the above , i would say the decoder is faulty.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest