DCC Concept accessory decoder

[RC06]

I have DCC Concept AD4fx accessory decoders and Gaugemaster BPPM10 Point Motors. The output on the decoder for wiring the motor is 2 wire + & - The input on the point motors are three wires + C - Should i use just the poss & neg on the motors or should i use the decoder output for momentary switching which hqs the three wires + C -

[Ron S]

from what I read re the Gaugemaster BPPM10 is 3 terminals - one for each coil plus a common but the AD4fx is for stall motors like cobalt & Tortoise not solenoids
https://www.dccconcepts.com/product/cob ... ay-output/
so for solenoids, you need a ADS-2fx accessory decoder

https://www.dccconcepts.com/manual/owne ... y-decoder/

[RC06]

Thanks Ron, realise my mistake now and will change the decoders for solenoid type