Page 2 of 3
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 5:27 pm
by Walkingthedog
You don’t need a different tender John if you use the plug and socket, just needs a bit of rewiring.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 6:12 pm
by footplate1947
Brian if you look at the service sheet for this R number Brian... the loco used the old chassis and ring field motor block (empty block) using the block to use pickups ect ...The old chassis does not have a convenient place to mount the plug socket. I would not do it with the old ring field chassis anyway.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 6:14 pm
by Walkingthedog
Must be space for those tiny Hornby sockets, they’re only 1/4 inch wide or less.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 6:21 pm
by footplate1947
You have look at the old style ring field chassis under side Brian. It is very low down on the track. If you cut hole out to fit plug there is not much left to hold bottom of chassis together. I think it would weaken it on the underside. If you are going to do that you may as well just run couple of extention wire into the tender and solder to the pick up and front pin wire. That was you dont have to cut up the chassis bottom.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 6:44 pm
by Walkingthedog
I agree it would be betterr without the plug. Maybe the socket could be in the loco??
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 6:55 pm
by footplate1947
I dont know what it wants a socket for, all it needs is good service.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 7:02 pm
by Walkingthedog
Neither do I but as you brought it up I thought I’d discuss it. A bit of adjustment and a clean will do the trick.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 7:12 pm
by footplate1947
No I didnt,,,,, clubman did post 8....john
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 7:15 pm
by Walkingthedog
Ha ha.....have a look at number 6.
Re: black 5 loco/ tender connection
Posted: Sat Jan 19, 2019 7:19 pm
by footplate1947
Did I,,,,,,,, wish I hadn't,,,,,,,, I gave bad advice then. Must admit I had not looked at the chassis at that point and noticed it had the old ring field chassis. Any way that is my defence your honour................