Page 119 of 119
Re: Wykeham - Somewhere in the south!
Posted: Wed Oct 23, 2024 7:53 pm
by bulleidboy
A couple of SR guards vans have arrived c/o TMC's recent "weathered sale". I now need to find some guards - Modelu??
IMG_1759 by
Barry Clayton, on Flickr
Re: Wykeham - Somewhere in the south!
Posted: Wed Oct 23, 2024 10:02 pm
by Walkingthedog
Wish I could weather like that.
Re: Wykeham - Somewhere in the south!
Posted: Wed Oct 23, 2024 11:24 pm
by bulleidboy
Likewise Brian - it probably takes them a few minutes to do each wagon etc.
Re: Wykeham - Somewhere in the south!
Posted: Fri Oct 25, 2024 11:16 pm
by cheshire lines
They certainly look the part.
Re: Wykeham - Somewhere in the south!
Posted: Sat Oct 26, 2024 3:20 pm
by bulleidboy
I have just had a frustrating few hours. I mentioned that I had replaced all of the Peco point motors with Cobalt Digital iP's - all motors programmed, installed and wired up, so I thought.Two of the points are Peco 3-way points, so there are three "frogs" and two point motors per point - I kept getting a short on one of the frogs everytime a loco ran over it. I had wired these up previously, some years ago, with no problems, and I really did know what I was doing, but to no avail. Eventually, having taken all of the wires out, and then putting them back I appear to have 100% success. Once the new control panel is in place "all" of the point motors will need programming again, but I believe this will happen automatically as each motor is attached to the DCC Concepts Alpha System - fingers crossed
