Page 1 of 1
Insulfrog points and seep motors
Posted: Wed Oct 09, 2019 10:38 am
by station master
Hi all
Does anyone have a basic wiring diagram for an insulfrog point and a seep motor, with momentary switch?
Can not seem to find one on the great wide web
G
Re: Insulfrog points and seep motors
Posted: Wed Oct 09, 2019 11:05 am
by Brian
Wire as below.
Assuming toggle switches, then the switches outer tabs to Seep A & B. Seep C to Power supply return or CDU Negative - output. Middle tabs of all switches are linked together and from one middle tab a wire goes to the CDU Positive + output terminal or the power supply other connection.
Seep tabs D, E & F are not used for points on an Insulated frog point and therefore can be used for other functions like point position indicators or colour light signal controls etc. Ideally use 16/0.2mm wire throughout.
Re: Insulfrog points and seep motors
Posted: Wed Oct 09, 2019 11:22 am
by station master
Brian you are a legend!!!
This is wonderful many thanks
G