Model Railway Forum

Hi there.hope against hope but does anybody have the colour coding for the above decoder.the 4 main colours (red,orange,black and grey are missing from the decoder output .thank you

Do you mean what colour wires go where?

Hi

I'm unable to find any information re an ESU lokPilot basic decoder with the number you've stated.
The ESU lokpilot web page states that there are two available LokPilot basic decoders but are different numbers to what you have given! Here is the web site for the Basic V1.0 http://www.esu.eu/en/products/former-pr ... basic-v10/ If it is one of those shown, then the wiring colours and their positions can be clearly seen from the image at the bottom of the page when its clicked on.

I have the colours and how to connect them,the problem is that its an old decoder and the 4 wires mentioned are detached from the plug and I don't know which wire goes to which terminal,the r wires are still connected but I don't need them.the website mentioned I have been onto but its the right decoder but the wires are not shown as its a plug in harness.its the r/h photo

PS to my reply,what I really need is a new harness ready plugged.

Is the plug an 8 pin in a 4 x 4 configuration or a 9 pin straight type?

it is a 9 pin straight connector,i have help from a friend who thinks he has a similar decoder so he is checking for me.i can see thro a magnifying glass that the terminal point for the 2nd wire in is labeled black and the 1st is possibly labelled red.thanks for your help both of you, i will let you know if i sort it.

Brian wrote: ↑Thu Feb 06, 2020 6:18 pm I'm unable to find any information re an ESU lokPilot basic decoder with the number you've stated.......

Looks like a mis-typing of the model number.
Should it be 52690 ?

mickrick wrote: ↑Thu Feb 06, 2020 8:08 pm .....the website mentioned I have been onto but its the right decoder but the wires are not shown as its a plug in harness.its the r/h photo

The decoder in the r/h photo is labelled as 21MTC, meaning it's a 21 pin direct fit decoder. There are no wires with this type of connector.

hello again,just to let you all know i have sorted the decoder out and have it running again.thanks for your time and efforts,mickrick