Model Railway Forum

Can anybody help please.I have a DCC concepts decoder with no other ID.It measures 20mm long and 12mm wide and is a 9 pin device.I need a 9 pin harness for it but have been unable to find one after hours of searching DCC concepts catalogue.I have bought a 9 pin JST style connector(810135) but the connector is too large to fit.any ideas anybody.thanks

Surely this is the correct harness..............HB

Thanks for info,it may well be the correct one,but it looks identical to the one I purchased.need to know physical size of connector.where was this info you have posted please

mickrick wrote: ↑Fri May 22, 2020 7:30 am Thanks for info,it may well be the correct one,but it looks identical to the one I purchased.need to know physical size of connector.where was this info you have posted please

from DCC Concepts I think, see link below
https://www.dccconcepts.com/product/dec ... st-3-pack/

From Concepts webpage as already stated..........I have found one in my bits box, the actual plug bit measures 9mm x 2mm..........HB

Thanks for confirmation that it is the harness that I need,9x2mm connector size was the clincher.thanks for all your help to you all