new control panel.
Posted: Sun Jun 07, 2020 4:57 pm
part way through building the next control panel for the railway.
started out as a case for a set of jump leads.
started out as a case for a set of jump leads.
Model Railway Forum
For all model railways and railway modellers
https://www.modelrailwayforum.com/
new control panel.
Page 1 of 1
Re: new control panel.
Posted: Sun Jun 07, 2020 8:04 pm
Ingenious...
Re: new control panel.
Posted: Mon Jun 08, 2020 2:12 pm
Looks really good - well done.
Q... You appear to have two sections switches with the same ID letters "PB". Is that an error or should one be PB-1 and the other PB-2? And no point switch for 101 points?
Im sure you have good reasons
Q... You appear to have two sections switches with the same ID letters "PB". Is that an error or should one be PB-1 and the other PB-2? And no point switch for 101 points?
Im sure you have good reasons
Re: new control panel.
Posted: Mon Jun 08, 2020 6:34 pm
bugger!!! i'd not renamed it. 101 should be below 102 and is currently marked 104. thanks for spotting that.
I'd seen the PB error and updated the drawing on my computer to give it the correct label of PC. I've made a few other changes like increasing the size of the coloured bands around the point switches.
Once i'm done with the wiring, i'm going to print a new sheet onto card, cut the holes out, laminate the sheet, then cut the holes out again, and replace the current sheet.
I'd seen the PB error and updated the drawing on my computer to give it the correct label of PC. I've made a few other changes like increasing the size of the coloured bands around the point switches.
Once i'm done with the wiring, i'm going to print a new sheet onto card, cut the holes out, laminate the sheet, then cut the holes out again, and replace the current sheet.