Heljan 89121 Turntable
Posted: Mon Nov 15, 2021 11:22 am
I have purchased one of these and have a couple of questions as the instructions are somewhat lacking [And out of date], The first question is fairly straitforward, On initial start up does the hut end of the table go to the entrance or exit of the table or does it not matter?
The second question is regarding the 55 to 65 stored positions in the controller for use with a DCC controller, [NCE Procab], The insructions are somewhat ambiguous in as much as one one hand that they can be changed but on the other hand the will not be changed. Problem being I have 80 odd sets of points numbered 1 > 90 that I have mapped out and to change them will take forever, Tom.
The second question is regarding the 55 to 65 stored positions in the controller for use with a DCC controller, [NCE Procab], The insructions are somewhat ambiguous in as much as one one hand that they can be changed but on the other hand the will not be changed. Problem being I have 80 odd sets of points numbered 1 > 90 that I have mapped out and to change them will take forever, Tom.