Wiring point motors for a Peco 3-way point
Posted: Mon Jun 26, 2023 11:22 pm
I'm considering how to use a DCD-ADS-4sx decoder to control a Peco 3-way electrofrog point fitted with Peco point motors. I see the challenge in that for the left route, one motor will move both sets of blades but the decoder won't 'know' that the other motor has moved and therefore one of the frogs will be still connected to the wrong supply. Is there any way to link the motors in the DCC programming for one direction of movement but have them work independently otherwise, so that a single command will set the left route, moving both motors in the same direction but in the right direction the motors respond to commands independently?
I can see a possible solution by using a relay operated in parallel with the point motor on the 3-way end of the point which then operates the other motor via the control panel switch input on the decoder, thus meaning the frog is also correctly switched by the decoder.
I've no idea if my question and possible solution makes sense, I've found this a challenge to explain! Please let me know one way or the other?
I can see a possible solution by using a relay operated in parallel with the point motor on the 3-way end of the point which then operates the other motor via the control panel switch input on the decoder, thus meaning the frog is also correctly switched by the decoder.
I've no idea if my question and possible solution makes sense, I've found this a challenge to explain! Please let me know one way or the other?