Page 1 of 1

Loading sound files onto Zimo Decoder.

Posted: Tue Aug 29, 2023 7:36 pm
by Too Tall
Please excuse the newbie question, new to Model railways and DCC this year !
If I was to get a Zimo sound decoder, how would I load loco specific sound packs on to it ?
At the moment searching has only provided one answer .. a £200 Zimo specific piece of hardware.
Could this not be done with a sprog 2 and JMRI ?

Re: Loading sound files onto Zimo Decoder.

Posted: Tue Aug 29, 2023 8:52 pm
by Itch45
you generally buy the decoder with a loco sound pre loaded, check out www.youchoos.co.uk who offer zimo decoders with their sound files pre loaded. Just pick the decoder you require with the desired sound. I have used this site many times and John is really helpful with any questions.

Re: Loading sound files onto Zimo Decoder.

Posted: Tue Aug 29, 2023 10:59 pm
by Too Tall
Great, thank you :)

Re: Loading sound files onto Zimo Decoder.

Posted: Wed Aug 30, 2023 10:37 am
by Brian
To answer your question .... The only way to add sound files to a sound decoder is via a specialist piece of equipment that allows sound files to be added. There are several makes, but they all cost a considerable amount. Hence as stated, its usual to buy the sound decoder pre-loaded with the correct type of sounds needed.

Re: Loading sound files onto Zimo Decoder.

Posted: Wed Aug 30, 2023 12:05 pm
by jed10
As has already bern stated, you usually buy the decoder with a sound project already installed. If want to load sound files to a Zimo MS decoder yourself this can be done with a Z21 controller if you are lucky enough to use one of these. It is loaded using the Z21 Maintenance app. You don't need any specialist equipment for this method.