Model Railway Forum

It has been several months since I've had the opportunity to run my factory new Hornby Lion. An exquisite model. As I was gently breaking her in reverse, both side rods popped out of the drive rod sockets. They refuse to pop back in. Any advice? I fear overdoing it and breaking some delicate thing, and they appear as delicate as butterfly wings.

Now the other side rod fell off, completely. One of the pins has a slight notch. No matter how I wiggle and press I cannot get it to slot back in. Two options: remove the things (yuk) or send them back over the ocean to Hornby, which I probably shall. It is a lovely model, but these side rods are my #$%#$%.

I am thinking of using a small c clamp and trying to gently press it in. It does not appear the notch corresponds to anything inside the wheel. If so, are the side rods opposed to each other, one up and one down? Please help before I do something I'll regret.

Sorry I can’t help Chops but there must be somebody on here with that loco.