Hornby Castle

A place to show what you are building, altering, kit bashing etc.
Post Reply
User avatar
Maz066
Posts: 110
Joined: Thu Oct 04, 2018 11:31 pm
Location: Berry NSW Australia
Contact:

Hornby Castle

#1

Post by Maz066 »

I have posted this on other forums in the hope of finding someone who has solved this problem

I have a Hornby Castle "Wellington R3105. A very recent model but a non runner. The crankpin on the leading drivers foul the crosshead on a R2 curve and jam. The result is the slide bars disconnect from the cylinders and chaos reigns


Image


It fouls by a fraction of a millimetre but it is enough to jam the motion. With this model Castle the slide bars are just pressed into the cylinder and can come loose easily. I am tempted to glue them in but I dont think that will solve the problem. It is not a good design. I cant send it back as I have added a chip, sound and a stay alive (Youchoos) and had to modify the tender to get it in

Question- Can I put spacer washers between the driving wheel and the frame to lessen the lateral travel of the driving wheel. How much would that effect its ability to handle a R2 curve
(This would be a major fix to remove a wheel from the axle and re-stablish quartering. Not sure it is worth it!

Any one had experience with this castle
Peter
User avatar
Steve M
Posts: 3461
Joined: Thu Oct 04, 2018 5:29 pm
Location: Rochester, Kent
Contact:

Re: Hornby Castle

#2

Post by Steve M »

Rather than ‘treating the symptom instead of the cause’, I would suggest trying to get a replacement for the faulty parts. Maybe Peter’s Spares or Hornby themselves. Failing that, carefully filing down the length of the crankpin would be better than budging the wheel movement.
"Not very stable, but incredibly versatile." ;)
User avatar
Walkingthedog
Posts: 4972
Joined: Thu Oct 04, 2018 5:51 pm
Location: HAZLEMERE, BUCKS.
Contact:

Re: Hornby Castle

#3

Post by Walkingthedog »

Should the pin be that long. Is it seated correctly?
Nurse, the screens!
Tony House
Posts: 39
Joined: Sat Nov 10, 2018 6:49 pm
Contact:

Re: Hornby Castle

#4

Post by Tony House »

Hi

Looking at the photo compared to the other side is the pin causing the issue the right way round, do the two sides match.

If it does match then one way of sorting the problem would be to file the offending pin down so it does not catch
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests