Class 66 not working

[SOOTYBRUM]

Hi, my N gauge class 66 (Gaugemaster/Dapol) is no longer working. Over Xmas, my grandson dropped it onto a hard floor. Have taken body shell off and found a loose part (see photos) . I run it on DC. . Is that a DCC chip or is it a part of the loco which has become detached. I am new to N gauge. Any ideas greatly appreciated. Thinking of sending it off to get it repaired if I cannot sort it.
Thanks for looking

[Walkingthedog]

Is it DCC ready or DCC fitted?

[brian1951]

A better picture is needed, the blanking plate or dcc chip has come apart. Topic moved to correct area.

[SOOTYBRUM]

Now working ok. The blanking plate has been reinstated and running ok . Thks replies.

[SOOTYBRUM]

Hi again, although it is running smoothly on my Kato track, when it comes to my x crossing to cross over the tracks, one of the bogies is getting derailed. .My other engines run fine over the crossing. Is it possible to remove the bogies? I cannot find my instruction manual and online there is only a one page sheet on oiling and dcc operation. Is it a simple job of pulling them off the body?

[brian1951]

DO NOT attempt to pull the bogies out. Firstly remove the body shell, then remove the screw that goes thru to the bogie from the top.

[Walkingthedog]

Not sure removing the bogie will solve the problem.

[SOOTYBRUM]

Unscrewed the bogie slightly, then tightened screw and it now seems to run ok in one direction over the crossing. Thks for advice. Brgds and a Happy New Year to you.