Bayview Halt

[wecpcs]

This is the layout dimensionally and it fits in a 10' x 8' shed, (Internal dimension 9.4' x 7.74')

It consists of several baseboard sections all bolted and dowelled together sitting on horizontal frame supports to the sides of the shed with legs to the floor at the front.

For possible future removal, the baseboard could be separated on a joint line to the right hand edge of the control area which would involve the minimal cutting of 5 rail sections avoiding all points and minimal wiring underneath. Then unscrewing the horizontal supports from the side of the shed after putting in temporary vertical supports from the lower shelf area to stop it collapsing and by cutting the front legs the whole layout could be removed in just 2 sections, making it easier to relocate in a different location.

[Brian]

Hi
Are you aware you have a Reverse Loop to the left of point number 14 in the drawing? How are you planning on dealing with this?

[wecpcs]

Hi Brian, yes I have a reverse loop module fitted and it works perfectly.

I am going to try again to offer it F.O.C. as you tried previously for me, where we had no success that time. I really want it to go to a good home and it would break my heart to dismantle it all after all my years of hard work and time, with your permission that is.

[Brian]

You can place it in the For sale section marked Free of Charge. But to be honest many people will not be able to accommodate it. But worth another try perhaps

[RogerB]

Are there any clubs nearby? R-

[wecpcs]

Not that I know of.

[X45]

Wow! fantastic