After the debacle of the PVA that wouldn’t clear I’ve now replaced it with a layer of clear casting resin.
That was not without problems either - the one bottle of the stuff supplied via Amazon was lumpy and had crystallised in the bottle. Presumably contaminated or out of date. However a small test mix in a plastic cup showed it as still just ok - some of the crystal lumps didn’t dissolve when mixed but as the surface will be textured with Modpodge it’s not the end of the world - the most important thing is that the resin has set. It’s been tinted at the mixing stage with a sprinkle of Humbrol weathering powder to give it a clear peaty look.
I’ve added waterfalls using Woodland Scenics water effects - dabbed and stilled onto a sheet of glass then pelf off and stuck into place when dried overnight. Touched up the edges with some more water effects and being left to cure.
Later I’ll texture the water surface then once it’s all dried clear, I’ll pick out some highlights in white.
2023-05-24_10-21-54 by
Steve Mumford, on Flickr