Scott Hill
-
- Posts: 908
- Joined: Thu Oct 04, 2018 7:42 pm
- Contact:
Re: Scott Hill
Looking good darkscot. Will be interested to see your progress with the canal as I am adding a board with a canal/wharf in the near future. Sorry for seeming a bit thick but how are you creating the lower level for the canal - I can’t make this out from your photo and am interested to know.
Re: Scott Hill
I have cut a section out of the baseboard. The foam insulation wall will form the back and left sides of the basin. There is going to be a canal bridge on the right to mask the edge of the base board. I will strengthen the back of the foam with card and fit another piece of card along the bottom. Then just fill it with water!
Modelling post war LMS. DCC control via Roco z21 & multiMAUS
-
- Posts: 908
- Joined: Thu Oct 04, 2018 7:42 pm
- Contact:
Re: Scott Hill
Despite the glorious weather I have could not resist getting started on my canal wall. Just given it a first paint and very pleased with how it is looking.
I know have to take the dog for a walk, along the canal!
I know have to take the dog for a walk, along the canal!
Modelling post war LMS. DCC control via Roco z21 & multiMAUS
- teedoubleudee
- Posts: 1116
- Joined: Fri Oct 05, 2018 2:53 pm
- Location: Downham Market
- Contact:
Re: Scott Hill
Nice fit, just needs durtying up a bit to blend in.
Most people are shocked when they find out how bad I am as an electrician
- bulleidboy
- Posts: 2294
- Joined: Thu Oct 04, 2018 6:30 pm
- Location: Basingstoke, Hants
- Contact:
Re: Scott Hill
Thank you, it almost looks like it was planned!
Modelling post war LMS. DCC control via Roco z21 & multiMAUS
Who is online
Users browsing this forum: No registered users and 3 guests